Search Products
CALL NOW: 1-888-77-DREAM[ Calls taken 9 am to 5 pm PST]
Queen Wood Foundation
- Product Description
Beautiful generic beige cover included. Works with all our mattress models including latex foam mattresses. 59.5 x 8 x 79.5
Description
Introducing the original state-of-the-art collapsible mattress foundation that is a breeze to move in and out of your home, and stronger than the old traditional models. With an 8-inch profile, it is made from solid Spruce, requires only 6 carriage bolts, and can be fully assembled in less than 10 minutes. With a simple, one-of-a-kind design, the entire foundation fits in a box that measures only 80" x 10" x 10"!
Advantages:
* 10 minutes approximate assembly time * No additional tools required * Ships via UPS or similar carrier * Easy to disassemble and store * Can transport in a minivan or SUV * Fits into attics, townhomes, and Cape Cods * Higher quality wood means better performance and durability
Assembling the founding is simple
Description
Introducing the original state-of-the-art collapsible mattress foundation that is a breeze to move in and out of your home, and stronger than the old traditional models. With an 8-inch profile, it is made from solid Spruce, requires only 6 carriage bolts, and can be fully assembled in less than 10 minutes. With a simple, one-of-a-kind design, the entire foundation fits in a box that measures only 80" x 10" x 10"!
Advantages:
* 10 minutes approximate assembly time * No additional tools required * Ships via UPS or similar carrier * Easy to disassemble and store * Can transport in a minivan or SUV * Fits into attics, townhomes, and Cape Cods * Higher quality wood means better performance and durability
Assembling the founding is simple
Step 1 is connecting the side rails. Lay the side rails and one end beam on the floor. Line-up both side rails with the channels on the end beam. Insert the bolts through the hols on both corners of the end beam and tighten.
Step 2 is placing the center rail through the middle of the end beam. (There are no bolts necessary to secure this rail to the end beam.) Then insert two bolts through the holes found on both outside corners of the end beam and tighten.
Step 3 is positioning the slats. Simply place the roll of slats on the top of the wooden structure at one end. Set the first slat behind the peg and unroll the slats across the top of the foundation. Set the last slat behind the other peg. (You may have to pull tight to get the slats snug).
Step 4, the final step, is putting the cover on the foundation. Slip the cover over the corner edges of the foundation with the fabric out. Tuck the excess under or use hand stapler to secure to wood.
That's it!
That's it!
